The purpose of this document is to show you how to use ISP3.10 software integrated with COMMGR V1.11 communication management software.
1. Installation of the software indicated in the table below
PLC Programming | |||||||
COMMGR V1.11 | Communication management software | AH series, AS series and DVP series PLCs | Windows® XP / 7 (32-bit / 64-bit) / 8/10 (64-bit) | 2019/11/12 | 9.42MB | – | |
ISPSoft V3.10 | PLC programming software | AH series, AS series and DVP series PLCs | Windows® XP / 7 (32-bit / 64-bit) / 8/10 (64-bit) | 2020/03/03 | 1,378MB | Please use with COMMGR for communication function |
After installing the necessary software, you must configure COMMGR
2 - Start menu:
Toolbar shortcut:
3 - With COMMGR started, the user can add connections to communicate with the PLC, as shown in the example:
COMMGR offers several ways to connect between the ISPSoft software and the PLC, it can connect in the following ways:
1. Example of how to set up a connection using the standard DVPACAB2A30 programming cable:
2. When clicking on Auto-Detect, a window will appear to select the station number of the PLC, if you do not know it should be left at “0” that the software will search for all stations:
3.After finding the PLC, the message “detected successfully” will click OK.
4. When finished, the created configuration will appear:
After completing the COMMGR communication process with the selected PLC, the ISPSoft software will be used to create the logic and download the program to the PLC.
1. After configuring COMMGR, open the PLC programming software - ISPsoft:
2. To create a project click on File-> New
The following window will appear:
3. After creating a project, it is necessary to inform the connection method (the connections defined in COMMGR)
To configure what type of connection go to Tools->Communication Settings…
4. A window will appear where the type of connection created in COMMGR must be selected:
5. To make sure that the connection to the PLC is correct, you can use the “System information” functionality, located on the PLC tab:
6. To create a program, go to Program-> POU-> New
7. The created program will open, it is possible to insert the logic and function blocks for the development of the PLC program:
8. After creating the logic, the program must be compiled and if there is no error. To download the program to the PLC, go to PLC-> Transfer->Download
9. After downloading the download to the PLC, you can monitor the created logic, go to PLC->OnlineMode
10. If the PLC is in STOP, it is possible to leave it in RUN mode by the software through PLC->RUN